What 2 (SmartDrive) Means
On Phase 1 SmartDrive machines the display module carried functions that later platforms moved to the motor control module, which is why Fault 2 here is a display module problem: an error was encountered while trying to read the pressure sensor. The action given is replacement of the control module.
Common Causes of 2 (SmartDrive)
- A read failure in the pressure sensing circuit
- A degraded connection between sensor and module
- A module whose sensing input has failed
🔧 One Safe Check You Can Try
Switch off at the wall for a full minute and try again. The water level reading is taken at the start of every fill, so a read error that was momentary will not survive a restart.
⚠ Why You Shouldn't Go Further Than That
- Unplug the machine before the console is opened, since on Phase 1 machines the control electronics sit in the console directly above the tub.
- Phase numbering matters on this platform, and a part chosen for the wrong phase will not work even where it physically fits.
- SmartDrive washers have been out of the US market for many years, so parts identification is a knowledge job rather than a catalog lookup.
- The console housing seals against splashes from below, and one refitted without that seal lets the next overfill reach the electronics.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.