What F2 Means
F2 shows up when the DishDrawer's wash motor fails to turn during the wash phase — the control board is watching for rotation it never detects, and without that confirmation the cycle can't move forward normally.
Common Causes of F2
- The wash motor physically jammed or seized
- Motor drive electronics or the Hall-effect rotation sensor has failed
- Worn rotor bearings keeping the motor from spinning freely
🔧 One Safe Check You Can Try
Cut power at the breaker for a couple of minutes and try again, which rules out a one-off glitch — beyond that, inspecting the motor itself isn't something to attempt without pulling the drawer from its housing, so leave that part to a technician.
⚠ Why You Shouldn't Go Further Than That
- Sitting just under the wet tub floor and wired into a live circuit, the wash motor is a genuine shock hazard to reach unless the unit is fully de-energized first.
- Because the rotation sensor and the motor's driver electronics share the same wiring run, bumping the wrong connector while inspecting one can create a second, unrelated problem.
- Trying to free a jammed coupling by hand risks shearing it outright, which converts what could've been a simple clean-out into a full motor swap.
- Since a bad sensor and a bad motor can present almost identically, guessing wrong means paying to replace a part that was never actually to blame.
- Taking the drawer right out means unhooking it at the back, and it has to be squared to the cabinet again afterwards or the lid seal will not close evenly.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.